Engine, Removing: Notes
WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
After the high pressure line assembly, and when installing a new short engine, it is particularly important to tighten the fuel injector tensioning claw to the previously mentioned tightening specification, refer to OVERVIEW - FUEL INJECTORS
. Only tighten the tensioning claws >>hand tight<< after delivery when assembling the high pressure line in order to align the fuel injector. Engine damage may occur if not observed.
Special Tools And Workshop Equipment Required
- Pry Lever 80-200
- Engine and Gearbox Jack VAS 6931 or Engine/Gearbox Jack VAG 1383A
- Step Ladder VAS 5085
- Engine Bung Set VAS 6122
- Shop Crane - Drip Tray VAS 6208
- Hose Clip Pliers VAS 6362
- Locking Pin T10060A
- Engine Support T10497 with pins T10497/1
- Protective eyewear
- Protective gloves