Checking wiring
-- Remove the Engine Control Module - J623 -.
-- Using a Multimeter, Check the Camshaft Position (CMP) Sensor -G40- electrical harness connector to the Engine Control Module - J623 - electrical harness connector T60 for an open circuit.
| Camshaft Position (CMP) Sensor -G40- electrical harness connector terminals: | Engine Control Module - J623 - electrical harness connector T60 terminals: |
|---|---|
| 1 | 44 |
| 3 | 40 |
Specified value: 1.5 Ω Max.
If the specified value was Not obtained:
-- Check the wiring connection for an open circuit, short circuit to Battery positive or Ground
-- Check the wiring connection for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection and replace any open fuses.
-- Go to Final procedures
If the specified value was obtained:
-- If no faults were found Replace the Engine Control Module - J623 -.
-- Go to Final procedures