Secondary Air Injection Sensor 1, Checking
Special Tools And Workshop Equipment Required
- Multimeter
- Wiring diagram.
Test Requirements
- The Engine Control Module (ECM) - J623- fuses OK.
- The fuel filter OK.
- The battery voltage at least 12.5 V.
- All electrical consumers switched off (radiator fan must NOT run during test).
- A/C switched off.
- The fuel tank at least 1 /4 filled.
- The ignition switched OFF.
Test Procedure
-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK
Start Diagnosis
-- Remove the engine cover with air filter.
Checking Voltage
-- Disconnect the Secondary Air Injection Sensor 1 -G609- electrical harness connector.
-- Switch the ignition ON.
-- Using a multimeter, check the Secondary Air Injection Sensor 1 -G609- electrical harness connector using the chart below.
| Secondary Air Injection Sensor 1 -G609- electrical harness connector terminals: | Specified value: |
|---|---|
| 1 to Battery Positive | Battery Voltage |
| 3 to Ground | near 5 V |
| 4 to ECM pin T60/55 | 1.5 Ω Max. |
-- Switch the ignition OFF.
If The Specified Values Were Obtained:
-- Replace the Secondary Air Injection Sensor 1 -G609-.
If The Specified Value Was Not Obtained:
Checking wiring connections
-- Remove the Engine Control Module (ECM) -J623-.
-- Using a multimeter, check the Secondary Air Injection Sensor 1 -G609- electrical harness connector terminals to the Engine Control Module (ECM) -J623- electrical harness connector T60 terminals for an open circuit. Refer to Appropriate System Diagrams for pin locations.
| Secondary Air Injection Sensor 1 -G609- electrical harness connector terminals: | Engine Control Module (ECM) -J623- electrical connector T60 terminals: |
|---|---|
| 1 | 13 |
| 3 | 44 |
| 4 | 55 |
Specified Value: 1.5 Ω Max.
If The Specified Value Was Not Obtained:
-- Check the wiring for an open, high resistance or short to ground.
-- Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection.
If No Malfunction Is Detected In The Wiring:
-- Replace the Engine Control Module (ECM) -J623-.
-- Install the engine cover with air filter.
Final Procedures
After the repair work, the following work steps must be performed in the following sequence:
- Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
- If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
- If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .