Three Way Catalytic Converter, TWC Checking

Test requirements 

• Battery voltage at least 12.5 volts.
• Oxygen Sensors OK.
• No leaks or damage to exhaust system.

Function test 

-- Perform the function test in Diagnostic Mode 06. Refer to DIAGNOSTIC MODE 06 - READ TEST RESULTS FOR SPECIFIC DIAGNOSTIC FUNCTIONS .

-- Switch the ignition OFF.

If the specified values are exceeded: 

-- Check the exhaust system for leaks.

-- If necessary, repair the leak in the exhaust system.

-- Erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .

-- Perform a road test to verify Repair.

If the DTC does Not return: 

Generate readiness code. Refer to READINESS CODE .

If the DTC resets and no leaks are found in the exhaust system: 

-- Replace the catalytic converter with front exhaust pipe. Refer to the appropriate Service Information.

Final procedures 

After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
2. If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
3. If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .