Selector Lever Cable
Check the cable for ease of movement after installing it.
Removing
-- Move the selector lever into the "S" position.
-- Disconnect the selector lever cable from the transmission -1- and pull it out of the bracket -2-.
-- Be careful not to bend the cable. Do not use pliers otherwise the tabs could break off.
-- Pry the cable -1- off the ball head on the selector shaft lever -3- using a open end wrench -2-.
-- Lift the vehicle.
The heat shield and exhaust system components may need to be removed in order to remove the cables and/or selector mechanism. Refer to EXHAUST MANIFOLD
-- Remove the heat shield.
-- Remove the selector housing under the selector lever.
-- Remove the cable from the selector lever. Push the pin up using a screwdriver and push the pin forward -arrows- at the same time.
-- Remove the retainer plate from the cable sleeve. Always replace the retainer plate.
-- Remove the selector lever cable.
Installing
-- Loosen the cable adjustment bolt.
Do not grease the cable.
-- Route the selector lever cable so that it is free of tension and install it into cable bracket on the transmission but do not secure it yet.
-- Clip the selector lever cable into the bracket. Make sure that bracket does not touch the transmission fluid cooler.
Nuts: 8 Nm
-- Secure the cable with the pin to the selector lever and to the selector mechanism bracket with new retainer plate.
-- Install the selector housing, the heat shield and the exhaust system.
-- Check the cable after installing it. Refer to SELECTOR LEVER CABLE, CHECKING .