Cellular Telephone Operating Electronics Control Module -J412-, REMOVAL AND INSTALLATION: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Passat, 2014 Volkswagen Passat, 2013 Volkswagen Passat, and 2012 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the right front seat into its highest position and the move it all the back.

-- Turn off the ignition and all electrical consumers and remove the key.

Fig 1: Identifying Module Carrier And Cell Phone Operating Electronics Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the lever -2- for seat forward/backward adjustment up and hold it.

-- Push the module carrier -1- for the Cell Phone Operating Electronics Control Module -J412- -3- toward the outside in the direction of -arrow A- and lift it on the tunnel in the direction of -arrow B-.

-- Tilt the module carrier -1- for the Cell Phone Operating Electronics Control Module -J412- -3- out of the outer mount in the direction of -arrow C-.

-- Turn over the module carrier -1- for the Cell Phone Operating Electronics Control Module -J412- -3-.

Fig 2: Identifying Connector, Cell Phone Operating Electronics Control Module And Module Carrier

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and disconnect the connector -3- for the Cell Phone Operating Electronics Control Module -J412- -2-.

-- Open the retainer -arrow- for the Cell Phone Operating Electronics Control Module -J412- -2- in the module carrier -1-.

-- Remove the Cell Phone Operating Electronics Control Module -J412- -2- from the module carrier -1-.