Engine, Installing: Notes

WARNING: This page is about a different variant/trim than selected.

NOTE:

When guiding the engine/transmission assembly into the body, bring the subframe into contact with the body using the scissor lift table. "Pulling" the subframe up with the bolts can damage the threaded inserts.

-- Reconnect all lines, hoses and electrical connections that were disconnected for the removal procedure.

Installation is performed in the reverse order of removal, noting the following:

Tightening specifications, refer to TIGHTENING SPECIFICATIONS .

-- For the subframe tightening specifications, refer to Specifications .

-- Install the selector lever cable on the transmission. Refer to [For transmission(s) 09D] Removal and Installation .

-- Fill the transmission fluid. Refer to [For transmission(s) 09D] General Information .

-- Electrical connections and routing, refer to Wiring

-- Connect the Air Conditioning (A/C) lines.

-- Fill the power steering fluid.

-- Install the noise insulation panel.

-- Fill the cooling system. Refer to DRAINING AND FILLING .

If the subframe could not be secured during removal:

-- Perform a vehicle alignment. Refer to "Wheel Alignment" in General Information .

Observe the safety precautions that apply to road tests. Refer to SAFETY PRECAUTIONS .

-- Perform a road test and check all the Diagnostic Trouble Code (DTC) memories. Refer to the vehicle diagnostic tester.