LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2010 >> Touareg Base >> Repair and Diagnosis >> Engine Performance >> Ignition System >> 3.6L - Generic Scan Tool - Engine Code(S): BHK >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Engine Coolant Temperature Sensor 2, Checking >> Testing If Display Is Approx. - 40.0° C
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Testing If Display Is Approx. - 40.0° C

-- Disconnect the Engine Coolant Temperature (ECT) Sensor (on radiator) -G83- electrical harness connector -1-.

Fig 1: Identifying Engine Coolant Temperature (ECT) Sensor (On Radiator) Electrical Harness Connector
GWWA10-1568Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Using a jumper wire, connect the Engine Coolant Temperature (ECT) Sensor (on radiator) -G83- electrical harness connector terminals 1 to 2.

-- Turn the ignition ON.

-- Check the value indicated on the scan tool display.

Fig 2: Identifying 2-Pin Electrical Connector & Terminals
GWWA28-0040Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

If the value jumps to approx. 140.0° C

-- Switch the ignition OFF.

-- Replace the Engine Coolant Temperature (ECT) Sensor (on radiator) - G83-. Refer to the Repair Information.

If indication remains at approx. -40.0° C:

scientia non olet · About LEMON Manuals