B1006 - Bi-Level Switch Request Input Circuit Low: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.
For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS information.
Theory of Operation
The Bi-Level mode switch input changes when the switch is pushed down. An active DTC indicates that the switch is stuck in a pushed position. A stored DTC indicates that the switch was stuck in a pushed position for more than two minutes, but has since returned to its normal state.
- >>When Monitored:<< With the ignition on.
- >>Set Condition:<< If the Bi-Level mode switch is stuck in a pushed position for more than two minutes. This DTC has a maturing time of two minutes and a de-maturing time of two seconds. If the DTC's status changes from active to stored it will stay in memory for 100 ignition cycles.
| Possible Causes |
|---|
| OBJECT HOLDING SWITCH IN A PUSHED POSITION |
| A/C HEATER CONTROL |
NOTE:
This DTC must be active for the results of this test to be valid. Do not perform this test if this DTC is stored.