Ignition Coil: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition Coil

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the ignition coil over the studs on the bracket.

-- Install the 2 nuts to the ignition coil studs and tighten the nuts. Tighten the nuts to 12 Nm (106 in lbs).

-- Connect the wiring harness electrical connector to the ignition coil.

-- Position and install the spark plug wires to the ignition coil.

-- Reposition the power steering reservoir. Slide bracket over the mounting stud.

-- Install the 2 bolts to the power steering reservoir to intake manifold.

-- Tighten the lower nut to the stud on the ignition coil bracket.

-- Connect the negative battery cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .