Control Module And Hydraulic Unit, Installing
NOTE:
Do not remove sealing plugs at new hydraulic unit until the corresponding brake line is about to be installed.
If the sealing plugs are removed too early, brake fluid can escape. If this occurs, unit may not be sufficiently filled or adequately bled.
When installing, make sure that rubber installation pieces are not pressed out of bracket.
-- Installation is performed in the reverse order of removal.
-- Remove brake pedal actuator -V.A.G 1869/2-.
-- Bleed brake system, refer to BRAKE SYSTEM, BLEEDING
-- Enter radio code.
-- Code the ABS control module -J104- in "Guided Fault Finding".
| Tightening specifications: | |
|---|---|
Control module to ABS hydraulic unit
|
5.5 Nm |
| Hydraulic unit hex bolt to bracket | 8 Nm |
| Brake lines at ABS aggregate: | |
| Thread M 10 x 1 | 14 Nm |
| Thread M 12 x 1 | 14 Nm |