Left Rear Level Control System Sensor, AWD
Special tools and workshop equipment required
- Torque wrenchV.A.G 1331
Removing
-- Disconnect the connector.
-- Remove the bolts.
-- Remove left rear level control system sensor -G76-.
Installing
Install in reverse order of removal. Note the following:
The level control system sensor lever must point toward vehicle exterior.
-- Perform a basic setting on the adaptive chassis DCC. Refer to ADAPTIVE CHASSIS DCC, BASIC SETTING .
-- Perform a basic setting on the headlamps using Vehicle Diagnostic Tester in "Guided Fault Finding" function.
Tightening Specifications
| Component | Tightening Specification |
|---|---|
| Bolt to subframe/lower transverse link | 5 Nm |