Checking function
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Connect V.A.G 1551 scan tool ((V.A.G 1552). Start engine and select "Address word" 01 of engine control module. Engine must be running at idling speed.(Connecting scan tool and selecting engine control module, see VAG1551 SCAN TOOL, CONNECTING AND SELECTING ENGINE CONTROL MODULE .)
Indicated on display:
- Press keys 0 and 8 for function "Read measured value block" and confirm entry with Q key.
Indicated on display:
- Press keys 0, 2 and 8 for "Display group number 28" and confirm entry with Q key.
Indicated on display: (1 to 4 Display zones)
NOTE:
Checking the knock sensors must be performed during a test drive because the diagnosis of the knock sensors is not activated until the engine speed exceeds 1800 rpm and the engine is loaded by more than 40%.
- Perform a test drive and check knock control specifications on display (display zone 4).
Observe the valid safety precautions when performing a test drive, see SAFETY PRECAUTIONS .
DISPLAY GROUP 28: IGNITION, KNOCK CONTROL
| 1 | 2 | 3 | 4 | |
|---|---|---|---|---|
| Display group 28: Ignition, knock control | ||||
| Display | xxxx rpm | xxx.x% | xxx.x °C | Test OFF/Test ON Syst. OK. Syst. n. OK. |
| Indicated | Engine speed (in steps of 40) | Engine load | Coolant temperature | Diagnosis condition and Diagnosis result |
| Working range | 0 to 6800 rpm | 0.0 to 150.0% | -40.0 to 110.0 °C | --- |
| Specification | at least 1800 rpm | Up To 40.0% | 85.0 to 105.0 °C | Syst. OK. |
| --- | --- | --- | If the specifications are not achieved, see CONTINUATION: | |
If the specification is attained:
- Press -->key.
- Press keys 0 and 6 for function "End output" and confirm entry with Q key.
- Switch ignition off.