Abs Control Module And Hydraulic Unit Assembly Overview
WARNING: This page is about a different car, the 2010 Volkswagen Passat, 2009 Volkswagen Passat, 2008 Volkswagen Passat, 2007 Volkswagen Passat, and 2006 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.
ABS/EDL/ASR/ESP, TRW
- ABS Control Module (w/EDL) -J104-
It is not possible to separate the control module and hydraulic unit.
- Removing and installing, refer to CONTROL MODULE AND HYDRAULIC UNIT .
- ABS Hydraulic Unit -N55-
It is not possible to separate the control module and hydraulic unit.
- Removing and installing, refer to CONTROL MODULE AND HYDRAULIC UNIT .
- Brake Line
- To right front brake caliper.
- Identification: 5.25 mm diameter and tube fitting with M10 x 1 thread
- Marked on hydraulic unit with "VR".
- Brake Line
- To left rear brake caliper.
- Identification: 5.25 mm diameter and tube fitting with shorter thread M12 x 1
- Marked on hydraulic unit with "HL".
- Brake Line
- To right rear brake caliper.
- Identification: 5.25 mm diameter and tube fitting with M10 x 1 thread
- Marked on hydraulic unit with "HR".
- Brake Line
- To left front brake caliper.
- Identification: 5.25 mm diameter and tube fitting with shorter thread M12 x 1
- Marked on hydraulic unit with "VL".
- Brake Line
- Master brake cylinder/primary piston circuit to hydraulic control unit.
- Identification: 8.5 mm or 6 mm diameter and tube fitting with longer thread M12 x 1
- Marked on hydraulic unit with "HZ1".
- Brake Line
- Master brake cylinder/secondary piston circuit to hydraulic unit.
- Identification: 8.5 mm or 6 mm and tube fitting with longer thread M12 x 1
- Marked on hydraulic unit with "HZ2".
- Heat Shield
Allocation.
- Bolt
- 12 Nm
- Brake Booster
- On vehicles with a hydraulic brake booster, a vacuum sensor is installed. Refer to the BRAKE BOOSTER VACUUM SENSOR .
- Removing and installing, refer to BRAKE BOOSTER .
- Bracket
- Nut
- 20 Nm
- Rubber Insulation
- Bolt
- 10 Nm
- Bracket