Windshield Washer Fluid Level Sensor -G33-

WARNING: This page is about a different car, the 2010 Volkswagen Passat, 2009 Volkswagen Passat, 2008 Volkswagen Passat, 2007 Volkswagen Passat, and 2006 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.

The Windshield Washer Fluid Level Sensor is installed on windshield washer and headlamp cleaning system tank in front of right front wheel housing.

Removing:

-- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

-- Remove front bumper cover. Refer to Removal and Installation .

-- Disengage and disconnect harness connector -6- at Windshield Washer Fluid Level Sensor -7-.

Fig 1: Identifying Headlamp Washer Pump V11, Windshield Washer Pump V5, Windshield Washer Fluid Level Sensor G33 And Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Pull Windshield Washer Fluid Level Sensor -7- out of its rubber seal.

Installing:

Install in reverse order of removal, noting the following:

-- Bleed headlamp washer system after completing assembly work, refer to HEADLAMP WASHER SYSTEM, BLEEDING .