Window Regulator Basic Setting
WARNING: This page is about a different car, the 2011 Volkswagen Eos, 2010 Volkswagen Eos, 2009 Volkswagen Eos, 2008 Volkswagen Eos, and 2007 Volkswagen Eos. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Window regulator motor must operate with greatest possible operating force for window regulator basic setting. Therefore, it is necessary to leave the engine running.
Procedure for window regulator basic setting:
- Start engine.
- Completely lower side window.
- Close side window and block with hand. Side window lowers (reverses).
- Close side window again within 5 seconds and block with hand again. Side window stops.
- Close side window again within 5 seconds. Side window runs without pinch protection up to mechanical window regulator stop.
- Within 5 seconds, hold window regulator switch for 5 seconds. Now window regulator motor is adjusted to window regulator.
The following 3 side window to door window positions are possible:
- Side window runs up to height of door window. Side window adjustment is correct.
- Side window does not run up to height of door window. The side window must be corrected in height adjustment toward top, refer to ADJUSTING HEIGHT AND PARALLEL ALIGNMENT
- The side window runs higher than the door window. Side window must be corrected in height adjustment toward bottom, refer to ADJUSTING HEIGHT AND PARALLEL ALIGNMENT . Perform basic setting again after correction.