Front Window Regulator Motor

Front Window Regulator Motor

Removing

- Remove the front door trim panel..






- Secure the door window with adhesive tape to prevent it from falling down.

- Disconnect the connections - 3 -.

- Remove the bolts - 2 -.

- Remove the window regulator motor with the control module - 1 - from the subframe.

Installation

- Attach the window regulator motor by gently moving the door window up and down so that the splines between the window regulator motor and the cable reel can mesh together.






Tightening specification for window regulator motor screws - 2 -: 3.5 Nm

- Code the new window regulator motor using the Vehicle Diagnosis, Testing and Information System (VAS 5051 A).

- After coding, let the window regulator work in the one-touch up/one-touch down mode and pull the switch for 2 seconds. This way the window regulator motor recognizes its upper stop.

- Continue by performing the steps used in removal in reverse order.