Antitheft Mode Switch: Service and Repair

Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button

Special tools, testers and auxiliary items required
- Trim removal wedge VAS 3409

NOTE:
- To remove the Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360, anti-theft warning system must be deactivated.
- When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool (trim removal wedge VAS 3409, screwdriver) will be positioned, using commercially available adhesive tape.
- Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360 are located in B-pillar trim on drivers side.

Removing
- Switch off ignition, switch off all electrical consumers and remove ignition key.







- Carefully pry out Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360 using removal wedge VAS 3409 or a screwdriver.







- Release and disconnect the connector - arrow -.

Installing
Install in reverse order of removal.