Fastener Tightening Specifications
| Component | Fastener Size | Nm | ||||
|---|---|---|---|---|---|---|
| Cable Bracket to Oil Pump Cover Nut | - | 10 | ||||
| Mechatronic Cover Bolt 1, 2 | - | 10 | ||||
| Oil Drain/Inspection Plug | - | 45 | ||||
| Oil Filter Housing | - | 20 | ||||
| Oil Pump Cover Bolt 1, 2 | - | 8 | ||||
| Oil Pump to Transmission Bolt | ||||||
| -- All 4 Flat Head | - | 5 + 90° turn | ||||
| -- 3 Flat Head, Upper is Countersunk | ||||||
| -- Upper Countersunk | - | 8 | ||||
| -- 3 Flat Head | 8 + 90° turn | |||||
| Overflow Tube | - | 3 | ||||
| Selector Lever Cable Adjusting Bolt | - | 13 | ||||
| Selector Mechanism to Body Nut | - | 8 | ||||
| Selector Shaft Lever Nut | - | 20 | ||||
| Shift Housing to Selector Mechanism Nut | - | 9 | ||||
| Spring to Selector Mechanism Bolt | - | 3 | ||||
| Transmission Input Speed Sensor and Clutch Oil Temperature Sensor to Transmission Bolt | - | 10 | ||||
| Transmission Oil Cooler to Transmission Bolt | 20 + 90° turn | |||||
|
||||||
Starter to transmission bolts. Refer to SPECIFICATIONS .
Subframe to body bolts. Refer to SPECIFICATIONS .
Mechatronic Bolt Tightening Sequence and Specification
-- Install the new bolts -1 through 10- and tighten by hand.
-- Tighten the bolts in the sequence shown -1 through 10- to 5 Nm + an additional 90° (1 /4 ) turn.
Transmission to Engine Bolt Tightening Specifications
- M12 -
80 Nm
- If Insert tool 18 mm T10179 is used: 65 Nm.
- M10 -
40 Nm
- 2 -
Arrows
- Points to alignment pins
- Do not grease
Transmission Mount and Bracket Bolt Tightening Specifications
-- Install all new bolts by hand.
-- Tighten the transmission mount bracket -A- to transmission bolts -1- to 40 Nm + an additional 90° turn.
-- When tightening the transmission mount bolts -2-, the bracket -A- can be pried into the correct seating position with screwdriver. Tightening specification for the mount bolts -2- : 60 Nm + an additional 90° turn.