MOTRONIC Engine Control Module (ECM) -J623- Reprogramming

-- The new Engine Control Module (ECM) -J623- and immobilizer must be activated. Refer to ECM and immobilizer activation instructions.

Final procedures 

After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
2. If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
3. If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .