Vehicle Alignment Work Procedure Overview
Special tools and workshop equipment required
- Brake pedal actuator V.A.G 1869/2
Observe the following work sequence!
-- Pay attention to notes on wheel alignment device
Measuring procedure
| Start | → | Perform wheel run-out compensation. | → | Bounce vehicle | ||||||
| ↓ | ||||||||||
| Turn the steering wheel into the straight ahead position and secure it (1) | ← | Measure vehicle height | ← | Install brake pedal loading device V.A.G 1869/2 | ||||||
| ↓ | ||||||||||
| Check camber at front axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjusting, refer to FRONT AXLE CAMBER, CORRECTING | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check rear axle camber | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjusting, refer to REAR AXLE CAMBER, ADJUSTING | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check toe at rear axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjusting, refer to REAR AXLE TOE, ADJUSTING | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check caster at front axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Check axle parts and body | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check toe at front axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| End | ← | Yes | Adjusting, refer to FRONT AXLE TOE, ADJUSTING | |||||||
| ↑ | ↓ | |||||||||
| ↑ | ← | ← | ← | ← | ← | |||||
|
||||||||||