Radio Units And Radio Navigation System, Golf Plus

Removing

Before starting repair work, perform the following:

-- If necessary, remove CDs remaining in the unit. Refer to the operating instructions.

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

Now, perform the following work procedure:

-- Remove trim in center of instrument panel. Refer to Removal and Installation .

-- Remove bolts -arrows- on radio unit.

Fig 1: Radio Unit Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull radio unit out of installation compartment far enough until harness connectors on rear side of radio unit are accessible.

-- Press together the connector lock in direction of -arrows-.

Fig 2: Identifying Electrical Connection Lock

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Then swing mounting bracket up in direction of -arrow- and disconnect harness connector.

Fig 3: Identifying Mounting Bracket Rotated Up And Disconnected Electrical Connection

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disengage harness connectors -arrow- from antenna connections and disconnect them.

Fig 4: Disengaging Antenna Cable Electrical Connection Lock

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing

-- Connect and engage harness connectors to radio unit.

-- Slide radio unit straight into instrument panel.

NOTE:

While sliding in the radio unit, under no circumstances press on the display or control buttons since the radio unit may be damaged by doing this.

-- Secure radio unit with 4 bolts -arrows-.

Fig 5: Radio Unit Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Reinstall center instrument panel trim.

-- If necessary, deactivate antitheft coding. Refer to ELECTRONIC ANTITHEFT SYSTEM, DEACTIVATING

-- Check coding of radio unit and code radio unit again if necessary.

Radio unit coding, refer to RADIO COMPONENTS, ADAPTING