Emergency Starting For Faulty Communication Between ID Sensor and Control Module

Emergency Starting For Faulty Communication Between Id Sensor And Control Module

In the event that communication between ID sensor in ignition/starter switch button and Comfort System Central Control Module (J393) is faulty (e.g. ignition/starter switch button battery discharged), engine can be started via remote control ignition key.

- Remove the ignition/starter switch button from the electronic ignition lock.

- To do this, release catch - 1 - by pulling slide - arrow - on bottom side back and pulling start button - 2 - out of electronic ignition lock.





- Insert remote control ignition key into electronic ignition lock.

The ID sensor in ignition key is identified via a transponder in the electronic ignition lock and the steering is unlocked and start authorization is achieved.

Start process occurs in the same way as with the ignition/starter switch button.

• If ignition/starter switch button is reinserted into electronic ignition lock, make sure that locking latch - 1 - faces upward. Otherwise, the locking latch does not lock in the ignition lock.