Removal and Replacement

Data Bus On Board Diagnostic Interface (J533)

Removing:

• If Data Bus On Board Diagnostic Interface is to be replaced, the work procedure to read out the codes stored in the module must always be performed, refer to => [ Data Bus On Board Diagnostic Interface, Replace ] Data Bus On Board Diagnostic Interface (J533), Replace.

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Remove foot well cover on driver's side.

- Disengage harness connector - 1 - and disconnect it from Data Bus On Board Diagnostic Interface - 2 -.





- Press mounting pins - 3 - together - arrows - and out of holes.

- Remove Data Bus On Board Diagnostic Interface from vehicle.

Installing:

Install in reverse order of removal.