Removal and Replacement

Data Bus On Board Diagnostic Interface (J533)

The data bus on board diagnostic interface is located in the right side of the driver footwell next to the steering column.

• Before removing the data bus on board diagnostic interface, the work procedure to read out the codes stored in the module must always be performed. Refer to=> [ Replacing ] Replacing.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the driver side footwell cover.

- Disconnect the connector - 1 -.






- Press the tabs - 3 - together - arrows - and pull them out of the holes.

Installation

Install in reverse order of removal.