Section 90 (Front Suspension)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volkswagen Rabbit, 2009 Volkswagen GTI, 2008 Volkswagen Rabbit, 2008 Volkswagen R32, and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- 40 Front Suspension
- General Information
- Description And Operation
- Drive Axle Hex Bolt Connection, Loosening And Tightening
- Drive Axle Twelve-Point Bolt With Ribs, Loosening And Tightening
- Drive Axle Twelve-Point Bolt Without Ribs, Loosening And Tightening
- Drive Axle Twelve-Point Bolt, Loosening And Tightening
- Front Suspension Overview
- Wheel Bearing, Raising To Curb Weight Position
- SUBFRAME, Stabilizer Bar And Control Arms Assembly Overview
- Front Left Level Control System Sensor Assembly Overview
- SUBFRAME And Consoles, Securing
- SUBFRAME, Lowering
- Wheel Bearing Assembly Overview
- Suspension Strut Assembly Overview
- Drive Axle Overview
- Drive Axles Differences
- Drive Axle Heat Shields
- Drive Axle Assembly Overview, With CV Joint VL90 And VL100
- Drive Axle Assembly Overview, With CV Joint VL 107 Bolted
- Drive Axle Assembly Overview, With CV Joint VL107 Attached
- Drive Axle Assembly Overview, With Triple Roller Joint AAR2600I
- Drive Axle Assembly Overview, With Triple Roller Joint AAR3300I
- Specifications
- Diagnosis And Testing
- Removal And Installation
- Left Front Level Control System Sensor
- SUBFRAME, Without Steering Gear
- SUBFRAME, With Steering Gear
- SUBFRAME Bonded Rubber Bushing, Fwd
- SUBFRAME Bonded Rubber Bushing, AWD
- Ball Joint
- Control Arm With Mounting Bracket
- Left Control Arm With Mounting Bracket, DSG And Automatic Transmission
- Control Arm With Mounting Bracket, Right Side On Vehicles With 6-Cylinder Engine
- Control Arm Bonded Rubber Bushing
- Mounting Bracket With Control Arm Bearing
- Stabilizer Bar
- Wheel Bearing Unit, 3-Point Mount
- Wheel Bearing Unit, 4-Point Mount
- Wheel Bearing Housing
- Strut
- Drive Axle With CV Joint
- Left Drive Axle With Mounted CV Joint
- Right Drive Axle With Mounted CV Joint
- Drive Axle With Triple Roller Joint AAR2600I,
- Drive Axle With Triple Roller Joint AAR3300I,
- Intermediate Shaft
- Disassembly And Assembly
- Strut
- Drive Axle With CV Joint VL90 And VL100
- Drive Axle With CV Joint VL107
- Notes
- Removing outer constant velocity joint
- Installed Location of Spring Washer and Thrust Washer on Outer Joint
- Drive off Cover for Inner Joint
- Removing the Inner CV Joint
- Installed Location of Spring Washer on Inner Joint
- Pressing on Inner CV Joint
- Tightening Hose Clamp on Outer Joint
- Tensioning Clamp on Small Diameter
- Intermediate Shaft
- Drive Axle With Mounted CV Joint VL107
- Drive Axle With Triple Roller Joint AAR2600I
- Drive Axle With Triple Roller Joint AAR3300I
- Special Tools