Telephone Operating Electronics Control Module, Rabbit Sedan Through 05.06

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volkswagen Rabbit, 2009 Volkswagen GTI, 2008 Volkswagen Rabbit, 2008 Volkswagen R32, and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Telephone Operating Electronics Control Module, Rabbit Sedan Through 05.06

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The telephone operating electronics control module is installed under the front right seat.

Removing

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

-- Remove right front seat. Refer to Removal and Installation

-- Remove screws -arrows-, disconnect connectors -A- and remove bracket with antenna selection control module.

Fig 2: Antenna Selection Control Module Screws, Bracket And Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip sill trim and fold carpet back.

-- Fold both latches on plastic bracket in direction of -arrow- and remove telephone operating electronics control module.

Fig 3: Telephone Operating Electronics Control Module Latches

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release connector by pressing on catch spring -A- and swing bracket in direction of -arrow-.

Fig 4: Connector And Catch Spring

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release connector by pressing on catch spring -arrow- and remove connector.

Fig 5: Releasing Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing

Install in reverse order of removal.