Windshield Washer Fluid Level Sensor -G33-

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volkswagen Rabbit, 2009 Volkswagen GTI, 2008 Volkswagen Rabbit, 2008 Volkswagen R32, and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Depending on equipment, the component location of the windshield washer fluid level sensor may deviate slightly from the illustrations. Removal is identical.

Removing

-- Turn off the ignition and all electric consumers and remove the key.

-- Remove front bumper cover. Refer to Removal and Installation .

-- Disconnect harness connector -1- on windshield washer fluid level sensor.

Fig 1: Identifying Windshield Washer Fluid Level Sensor G33 And Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull windshield washer fluid level sensor -2- out of its rubber seal.

-- If necessary, collect the draining fluid in a suitable container.

Installing

Installation is performed in the reverse order of removal. Note the following:

-- Bleed headlamp washer system after completing assembly work. Refer to HEADLAMP WASHER SYSTEM, BLEEDING .