Telephone Operating Electronics Control Module, Golf Plus Through 05.06

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volkswagen Rabbit, 2009 Volkswagen GTI, 2008 Volkswagen Rabbit, 2008 Volkswagen R32, and 2008 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

-- Remove right front seat. Refer to Removal and Installation

-- Raise carpet slightly in connector station area. The control module is installed below.

-- Unclip both plastic tabs -arrows-.

Fig 1: Plastic Tabs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove control module -arrow- with wires connected.

Fig 2: Identifying Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Operate catch -arrow- at red harness connector and disconnect harness connector.

Fig 3: Identifying Catch At Red Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press catch -A- on black harness connector and fold the bracket over in direction of arrow -B-.

Fig 4: Identifying Catch On Black Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect electrical connection.

Installing

Install in reverse order of removal.