Parts of the ignition, removing and installing (Vehicles with engine code AWD)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
The following list pertains to Fig 1.
- Connector
- Black, 4-pin
- 10 Nm
- Ignition coil with power output stage (Ignition Coil 1 with Power Output Stage -N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage - N291-, Ignition Coil 4 with Power Output Stage -N292-)
- Checking, see IGNITION COILS WITH POWER OUTPUT STAGES, CHECKING
- Spark plug, 30 Nm
- remove and install with 3122 B
- Type and spark plug gap, see TEST DATA, SPARK PLUGS
- 3-pin harness connector
- Terminals are gold-plated
- Brown for Knock Sensor (KS) 1 -G61-
- Black for Knock Sensor (KS) 2 -G66-
- 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
- Knock Sensor (KS) 1 -G61-*
- Terminals of sensor and connector are gold-plated
- Checking, see CHECK KNOCK SENSORS
- Knock Sensor (KS) 2 -G66-*
- Terminals of sensor and connector are gold-plated
- Checking, see CHECK KNOCK SENSORS
- Connector
- black, 3-pin
- 10 Nm
- Camshaft Position (CMP) Sensor 2 - G163-*
- Checking, see CHECK CAMSHAFT POSITION (CMP) SENSOR
- 25 Nm
- Washer
- Conical
- Face plate
- For Camshaft Position (CMP) Sensor 2 -G163-
- note position when installing
- Ground (GND) wire
- Do not loosen or tighten unless ignition is switched off.
- 10 Nm
- Do not loosen or tighten unless ignition is switched off.