Selector Lever Cable, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Check protective sleeve for damage.

The protective sleeve can only be replaced together with selector lever cable.

Check that protective sleeve is correctly installed. Do not install protective sleeve twisted.
Do not bend or kink selector lever cable.

Selector lever and selector shaft lever are in "P" position and front wheels are blocked.

Fig 1: Identifying Selector Lever, Cable & Securing Plate

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Guide selector cable - 3 - into mounting bracket and press onto selector lever - 2 -.
Install new locking plate - 1 - for selector lever cable onto mounting bracket.

Installation position:

The angled end of locking plate must face end of selector lever cable.

Move selector lever from "P" to "2".

Selector lever mechanism and selector lever cable must move freely. Replace selector lever cable, refer to Selector lever cable, removing and installing or repair selector lever mechanism as necessary.

Move selector lever to "P" position.
Bolt cover with glued-on seal to mounting bracket. When doing this, check position of seal.

Fig 2: Identifying Selector Mechanism Bolts A & B

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tighten nuts - arrows A - to 10 Nm.
Then tighten both bolts - arrows B - to 25 Nm.
Push protective sleeve of selector lever cable into cover.
Install front and middle heat shields for tunnel.
Hook selector lever cable into retainer on front heat shield.
Reassemble exhaust system. Refer to 26 - EXHAUST SYSTEM, EMISSION CONTROLS .

Fig 3: Hook Selector Lever Cable Into Retainer

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Hook selector lever cable - 1 - into retainer - arrow - on engine.

Fig 4: Identifying Selector Lever And Selector Lever Cable

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen bolt - 2 - on front ball socket - 1 - of selector lever cable.
Place selector lever cable in transmission support bracket and push onto selector shaft lever - 4 - using pliers.
Install new securing clip - 3 - to selector lever cable at transmission support bracket.
Tighten bolt - 2 - to 13 Nm.

Check selector mechanism, refer to Selector mechanism, checking .