Engine Mount Adjustment, Checking

WARNING: This page is about a different car, the 2015 Volkswagen Passat, 2014 Volkswagen Passat, 2013 Volkswagen Passat, and 2012 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.

There must be at least 10 to 13 mm -a- between the engine mount bracket -2- and right longitudinal member.

Fig 1: Identifying Casting Edge On Engine Support Location
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
The casting edge on the engine mount bracket -2- must be parallel to the engine mount support arm -1-, dimension -x- must be the same at the front and the rear.

Only if there is a noise (the engine or transmission hitting the longitudinal member when driving around curves) and dimension -a- is NOT within 10 to 13 mm:

-- Adjust the engine mount. Refer to ENGINE/TRANSMISSION MOUNT, ADJUSTING .