Vehicle Electrical System Control Module, From 06.09

NOTE:

The relay carrier is clipped under the vehicle electrical system control module and can be removed.

If the Vehicle electrical system control module -J519- is being replaced, then always perform the procedure to read out the code stored in the module. Refer to VEHICLE ELECTRICAL SYSTEM CONTROL MODULE -J519-, FROM 06.09, CODING .

Removal

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

NOTE:

The relay carrier under the vehicle electrical system control module is not installed in all vehicles. Depending on the vehicle equipment level, the vehicle may or may not have a relay carrier.

-- Remove the relay carrier on the vehicle electrical system control module. Refer to RELAY CARRIER ON VEHICLE ELECTRICAL SYSTEM CONTROL MODULE, FROM 06.09 .

-- Disconnect the connectors.

Fig 1: Identifying Vehicle Electrical System Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press both locking mechanisms -arrows- and move the vehicle electrical system control module downward.

-- Pull the vehicle electrical system control module out of the bracket downward and opposite the drive direction.

Installation

Install in reverse order of removal, noting the following:

-- Install the vehicle electrical system control module into the bracket and then push on it until it audibly engages.