High-Intensity Gas Discharge Lamp Control Module, Removing and Installing

High-intensity Gas Discharge Lamp Control Module, Removing And Installing

NOTE:
- Left High-intensity Gas Discharge Lamp Control Module J343 and Right High Intensity Gas Discharge Lamp Control Module J344 is not capable of On Board Diagnostic (OBD).
- Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at right headlamp.
- Replacement of Left High-intensity Gas Discharge Lamp Control Module J343 and of Right High-intensity Gas Discharge Lamp Control Module J344 is performed analogously.

- Check headlamp for function.
- Check and adjust headlamp aim if necessary.

Removing:

NOTE: Observe safety notes

- Remove headlamp.







- Remove mounting bolts -3- and remove gas discharge lamp control module -2- from headlamp connector position -1-.

Installing:
Install in reverse order of removal, noting the following:

NOTE: Make sure seals have proper seating when installing High-intensity Gas Discharge Lamp Control Module. Water intrusion will damage headlamp.