Ignition System Components Overview
NOTE:
The engine speed sensor -G28- -item 16- CYLINDER BLOCK AND LUBRICATION COMPONENTS OVERVIEW is on the cylinder block.
- Ignition Coil with Power Output Stage -N70, N127, N291, N292, N323, N324-
- Remove and install using the puller for ignition coil T10095 A.
- Connector
- Black, 4 pin
- Use the assembly tool T10118 to pull off.
- Bracket
- For the harness connector of the Knock Sensor (KS) 1.
- Bolt
- 10 Nm
- Connector
- Black, 3-pin
- Sensor contacts and connector contacts are gold plated.
- Knock Sensor 1 -G61-
- Installation location: between cylinders 1 and 3.
- Bolt
- 20 Nm
- Tightening specification affects the function of the KS.
- Exhaust Camshaft Adjuster
- Identification: 32A
- With sensor wheel for the Camshaft Position (CMP) sensor 2.
- Installing, refer to CAMSHAFT ADJUSTER WITH TIMING CHAIN, INSTALLING .
- Cover
- Removing and installing, refer to TIMING CHAIN COVER OVERVIEW .
- Seal
- Always replace.
- Camshaft Position Sensor 2 -G163-
- For the exhaust camshaft.
- Sensor contacts and connector contacts are gold plated.
- Bolt
- 10 Nm
- Connector
- Black, 3-pin
- Sensor contacts and connector contacts are gold plated.
- Mark the connector before removing.
- Camshaft Position Sensor -G40-
- For the intake camshaft.
- Sensor contacts and connector contacts are gold plated.
- Knock Sensor 2 -G66-
- Installation location: between cylinders 4 and 6.
- Sensor contacts and connector contacts are gold plated.
- Connector
- Black, 2-pin
- Sensor contacts and connector contacts are gold plated.
- Intake Camshaft Adjuster
- Identification: 24E
- With sensor wheel for the CMP sensor.
- Installing, refer to INTERMEDIATE SHAFT AND TIMING CHAINS, INSTALLING .
- Spark Plug
- 20 Nm
- If the spark plug is replaced, lubricate the ignition coil with power output stage. Refer to IGNITION COILS WITH POWER OUTPUT STAGE .
- Remove and install using spark plug removal tool 3122B.
- Type and electrode gap, refer to SPARK PLUG TECHNICAL DATA .
- Control Housing
- Camshaft adjustment valves, removing and installing. Refer to CAMSHAFT ADJUSTER VALVES .
- Removing and installing, refer to CAMSHAFTS .