Ignition System, Servicing: Notes
The following table provides a quick link to all chapters in this article.
| Ignition Coil with Power Output Stage, Checking. Refer to IGNITION COIL WITH POWER OUTPUT STAGE, CHECKING . |
| Camshaft Adjustment Valve 1 N205, Checking. Refer to CAMSHAFT ADJUSTMENT VALVE 1, CHECKING . |
| Knock Sensor, Checking. Refer to KNOCK SENSOR, CHECKING . |
| Camshaft Position Sensor G40, Checking. Refer to CAMSHAFT POSITION SENSOR, CHECKING . |
For all Ignition/Glow plug system component locations. Refer to IGNITION SYSTEM COMPONENT OVERVIEW .
For all Ignition/Glow plug system removal/installation procedures and torque specifications. Refer to REMOVAL AND INSTALLATION , and SPECIFICATIONS .
All manufacturer's special tools as well as common tools may contain a manufacturer specific part number. These tools may be substituted with an equivalent aftermarket tool, or are available for purchase from the manufacturer.
Manufacturers special tools as well as common tools that contain a manufacturer specific part number may be referenced in the test procedure illustrations, showing the tool use or installation. If the manufacturer specific tool is not being used, an equivalent aftermarket tool may be installed in the same manner as the manufacturer's special tool.
The use of nails, paper clips, or another unauthorized materials to back-probe electrical harness connectors is strictly prohibited and may cause damage to the electrical harness connectors, terminal ends or damage to a component. Use only the manufacturers test lead kit or an equivalent aftermarket test lead kit for back-probing all electrical harness connectors.