Readiness code, generating: Notes

Requirements 

Fig 1: Fuses In E-Box (Plenum Chamber, Right)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Fuses in E-box (plenum chamber, right) must be OK:

Refer to Electrical Wiring Diagrams and Component Locations

Fig 2: Fuses In Fuse Box (Instrument Panel, Left)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Fuses in fuse box (instrument panel, left) must be OK:

Refer to Electrical Wiring Diagrams and Component Locations

• Battery voltage (both batteries) must be at least 11.5 Volts.
• All electrical consumers, such as, lights and rear window defroster, must be switched off.
• For vehicles with automatic transmission, selector lever must be in -P-.
• If vehicle is equipped with an A/C system, it must be switched off.

• Ground (GND) connections between engine, transmission, and chassis must be OK.
• There must not be any DTCs stored in DTC memory. Refer to Diagnostic mode 3: Check DTC Memory , Diagnostic mode 3: Check DTC memory.
• Intake air temperature 5 to 35 ° C. Refer to Diagnostic mode 1: Check measured values , Diagnostic mode 1: Check measured values; PID 15: Intake Air Temperature (IAT)