Sae U0XXX Diagnostic Trouble Codes

For additional monitor strategy information. Refer to the => Bosch Motronic MED 9.1 OBD System Strategy document.

Control module and output signals

DTC	Error Message	Diagnostic Procedure	Malfunction Criteria and Threshold Value	Secondary Parameters with Enable Conditions	Monitoring Time Length	Frequency of checks, MIL Illumination
U0001	High Speed CAN Communication Bus	-- Refer to CAN-BUS TERMINAL RESISTANCE, CHECKING .	CAN message, No feedback	Battery voltage, 9.49-16.5 V	0.5 Seconds	2 DCY
U0100	Lost Communication with ECM/PCM	-- Refer to CAN-BUS TERMINAL RESISTANCE, CHECKING .	Failure of all CAN engine messages, Time out more than 490 ms Failure of all CAN engine messages but not all CAN messages, Time out more than 1010 ms	No bus off error No error failure of all CAN messages No error failure of all CAN engine messages Terminal 15 Voltage, > 9 V for more than 500 ms > 500 ms after reset	1 Second
U0101	Lost Communication with TCM	-- Refer to TRANSMISSION CONTROL MODULE J217 CAN-BUS TERMINAL RESISTANCE, CHECKING .	Checksum check Failed Message counter check failed Time out check No message received by ECM	--	0.5 Seconds	2 DCY
U0302	Software Incompatibility with Transmission Control Module	-- Refer to TRANSMISSION CONTROL MODULE J217 CAN-BUS TERMINAL RESISTANCE, CHECKING .	AT vehicle ECM coded as MT vehicle	--	800 ms	--