Instrument Cluster

NOTE:

Before removing instrument cluster, the work procedure INSTRUMENT CLUSTER, ADAPTATION/REPLACING must be performed in every case to read out data stored in the control module.

Removing:

-- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

-- Remove driver's side panel. Refer to Removal and Installation .

-- Remove instrument cluster panel. Refer to Removal and Installation .

-- Remove mounting bolts -arrows- of instrument cluster -1-.

Fig 1: Identifying Instrument Cluster And Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

The fixed electrical connection to the instrument cluster is disconnected automatically when the cluster is pulled out of the instrument panel opening. Harness connector is installed permanently in vehicle and is disconnected automatically when pulling out instrument cluster.

-- Pull instrument cluster -1- out of instrument panel.

Installing:

Install in reverse order of removal.

-- After installing, test the functions of the instrument cluster.