Vehicle Electrical System Control Module -J519- Output Diagnostic Test Mode

Special tools and workshop equipment required

NOTE:

It depends on the vehicle equipment whether the components listed below can be checked.

The following components and functions can be checked via output Diagnostic Test Mode (DTM) of vehicle electrical system control module:

Left Parking Lamp -M1-, Right Parking Lamp -M3-, Left Taillamp -M4- and Right Tail Lamp -M2-
Left Low Beam Headlamp -M29- and Right Low Beam Headlamp -M31-
Left High Beam Headlamp -M30- and Right High Beam Headlamp -M32-
Left Low Beam Reflector Motor -V294- and Right Low Beam Reflector Motor -V295-
Left Front Fog Lamp -L22- and Right Front Fog Lamp -L23-
Right Back-Up Lamp -M17-
Left Brake Lamp -M9-, Right Brake Lamp -M10- and High-mount Brake Light -M25-
Left Rear Fog Lamp -L46-
License Plate Light -X-
Left Front Turn Signal Lamp -M5-, Driver Exterior Mirror Turn Signal Lamp -L131- and Left Rear Turn Signal Lamp -M6-
Right Front Turn Signal Lamp -M7-, Front Passenger Exterior Mirror Turn Signal Lamp -L132- and Right Rear Turn Signal Lamp -M8-
Left Footwell Light -W9- and Right Footwell Light -W10-
Interior light dimmed
Instrument illumination of all buttons and switches and of instrument cluster
Terminal 30 power supply relay -J317- (B+)
LED heated rear window / heated rear window
LED for heated exterior mirror / heated exterior mirror
Enabling - Sunroof
Enabling of seat heater
Fuel Pump (FP) Relay -J17-
Headlamp Washer System Relay -J39- and Headlamp Washer Pump -V11-
Front windshield wiper
Wiper module reversing point
Windshield and Rear Window Washer Pump -V59- at front
Windshield and Rear Window Washer Pump -V59- at rear
Horn Relay -J4-, High Tone Horn -H2- and Low Tone Horn -H7-

-- Connect the VAS5051B.

-- On the VAS5051B, select "Guided Fault Finding".

-- Using the "Go To" button, select "Functions/Component selection" and the following menu options in sequence: