Transmission Fluid Level, Checking And Filling: Checking

-- Turn off the engine.

The transmission fluid temperature must not be more than approximately 30°C (86°F) at the start of the test.

The transmission is not in emergency running mode, and the fluid temperature is not higher than 30°C (86°F).
The vehicle is horizontal
The selector level is in the "P" position.

-- Connect the tester and move through the selections until it is ready for operation. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Press the right button Guided Functions .

-- Select the vehicle, the transmission and check ATF level .

-- Press the → button.

-- Start the engine.

-- Lift the vehicle.

-- Place a drip tray under the transmission.

-- Press the → button.

If the test temperature is 35 to 45°C (95 to 113°F):

-- Remove the plug from the oil pan.

Fig 1: ATF Level Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The fluid flows out of the overflow tube.

Fig 2: Example Of Filler Tube As It Is Installed In Transmissions

Courtesy of VOLKSWAGEN UNITED STATES, INC.

If fluid continues to drip out of hole:

The fluid does not need to be topped off.

-- Install and tighten the plug with a new seal to 27 Nm. The level check is now completed.

If no fluid drips out of the hole:

-- Fill with transmission fluid.