Comfort System Central Control Module J393, emoving and installing
Removing:
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove glove compartment → 68 INTERIOR EQUIPMENT .
Fig 1: Pulling Retaining Tab Of Bracket Of Comfort System Central Control Module J393 And Sliding Comfort System Central Control Module J393
- Pull retaining tab - 1 - of bracket of Comfort System Central Control Module J393 in - direction of arrow - and slide control module until recesses - 2 - and - 3 - line up.
NOTE:
- Electrical connections can only be disengaged and disconnected when recesses - arrows - are lined up.
- Disengage electrical connections and disconnect from Comfort System Central Control Module J393.
NOTE:
- The number of electrical connections depends on vehicle equipment.
- Remove nuts - arrows -.
- Remove bracket with Comfort System Central Control Module J393.
- Pull retaining tab - 1 - in - direction of arrow B - and slide Comfort System Central Control Module J393 - 2 - out of bracket in - direction of arrow A -.
Installing:
Install in reverse order of removal, noting the following:
NOTE:
- After installing a new Comfort System Central Control Module, it must be coded.
- Electrical connections can only be connected and engaged when recesses - arrows - of harness connectors line up.