Transmission Control Module (TCM) J217 replacing, 5 Spd. Automatic Transmission 09G
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for enabling/locking the Transmission Control Module (TCM) J217.
- To perform adaptation of the anti-theft immobilizer. Refer to the Ebahn website.
Procedure
Check the identification of the previous Transmission Control Module (TCM) J217 as follows:
- Connect the scan tool.
- Switch the ignition on.
- Select "Diagnostic mode 9: Vehicle information."
- Select the "Test-ID 04: Calibration identification".
- The Transmission Control Module (TCM) J217 identification will be displayed, e.g.: 09G27750 L 0301
- End diagnosis and switch the ignition off.
Removal
- Remove the wiper arms and wind cowl.
- Disconnect the electrical harness connector in the direction of the arrow.
- Remove the mounting bolts - arrows -
Installation
- Installation is performed in the reverse order of removal. note the following:
- Check the identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
- Code the Transmission Control Module (TCM) J217.
Final procedures
- Check the DTC memory.
- If necessary, erase DTC memory of the Transmission Control Module (TCM) J217..
- If the DTC memory was erased, generate readiness code.
NOTE:
- To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for enabling/locking the Transmission Control Module (TCM) J217.
- To perform adaptation of the anti-theft immobilizer. Refer to the Ebahn website.
Procedure
Check the identification of the previous Transmission Control Module (TCM) J217 as follows:
- Connect the scan tool.
- Switch the ignition on.
- Select "Diagnostic mode 9: Vehicle information."
- Select the "Test-ID 04: Calibration identification".
- The Transmission Control Module (TCM) J217 identification will be displayed, e.g.: 09G27750 L 0301
- End diagnosis and switch the ignition off.
Removal
- Remove the wiper arms and wind cowl.
- Disconnect the electrical harness connector in the direction of the arrow.
- Remove the mounting bolts - arrows -
Installation
- Installation is performed in the reverse order of removal. note the following:
- Check the identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
- Code the Transmission Control Module (TCM) J217.
Final procedures
- Check the DTC memory.
- If necessary, erase DTC memory of the Transmission Control Module (TCM) J217..
- If the DTC memory was erased, generate readiness code.
End diagnosis