4 Speed Automatic 01M

Vehicle Speed Sensor (VSS), checking (vehicles with 01M transmission)

Recommended special tools and equipment







- 10-222A engine support bridge with 10-222A-1 bracket for engine







- V.A.G 1331 torque wrench (5 to 50 Nm)

Requirements
- Selector lever must be in -P- position.
- Parking brake must be engaged.
- Ignition switched off.

Work procedure
- Determine whether a coded radio is installed. In this case, determine anti-theft coding.
- Switch ignition off and disconnect battery Ground (GND) strap.
- Remove battery.
- Remove battery holder.
- Remove air filter.







- Position 10-222A engine support bridge with 10-222A/1 brackets as shown and support engine/transmission in this position.
- Remove bracket for power steering pressure line.







- Remove mounting bolts (arrows) from transmission holder.







- Remove mounting bolts (arrows) for pendulum support and remove pendulum support.







- Lower transmission approx. 60 mm -dimension a-.
- Remove mounting bolt and remove sensor -1- from transmission.
- Disconnect harness connector from Vehicle Speed Sensor (VSS) -G68-.
Installation is performed in reverse order of removal.

- Replace O-ring.
- Install sensor and tighten to 10 Nm.
Tightening torques of transmission holder and of pendulum support:

- Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes