Work sequence
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- With engine at idle, connect Scan Tool (ST) VAG1551 / VAG1552 and select Engine Control Module (ECM) J248 with "Address word" 01. → Scan Tool VAS5051 , connecting , Scan Tool VAG1551 , connecting.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons 0 and 8 for "Read Measured value block" and confirm with Q button.
Indicated on display:
| Read Measured value block HELP Input display group number XXX |
- Press buttons 0 , 1 and 7 for "Display group number 17" and confirm with Q button.
Indicated on display: (1...4 = Display zones)
| Read Measured value block 17 → 1 2 3 4 |
- Check the readiness code in display zone 2
Specification: x000xxxx
and display zone 4
Specification: 0xxxxxxx
If specification is obtained:
- Press → button.
- Press buttons 0 and 6 for "End output" and confirm with Q button.
- Switch off ignition.
If specifications are not obtained:
- Press → button.
- Set readiness code → Readiness code, setting