Diagnostic mode 9: Vehicle information
Function
In this diagnostic mode, vehicle specific diagnostic data such as e.g. the control module versions will be displayed.
Requirement
- There must not be any DTCs stored in DTC memory. Refer to Diagnostic mode 3: Check DTC Memory , Diagnostic mode 3: Check DTC memory.
Work procedure
- Connect diagnostic tester. Refer to Diagnostic tester, connecting .
- Switch ignition on.
- Under address word 33, select "Diagnostic mode 9: vehicle information".
- Select desired vehicle information "Test-ID XX".
Display vehicle information
| PID |
Diagnostic mode |
Module number 10 Engine Electronics |
Module number 1A Transmission Electronics |
||
| 02: | Vehicle Identification Number (VIN) e.g.: | WAUZZZ... | --- | ||
| 04: | Calibration identification e.g.: | 8D0907551AB 0001 (Engine Control Module -ECM- identification) |
09G927750 L 0301 (Transmission Control Module -TCM- identification) |
||
| 06: | CVN (check sum) e.g.:
|
61C5ED44 (Engine Control Module -ECM-)
|
CA2B07B3 (Transmission Control Module -TCM-)
|
||
- End diagnosis and switch ignition off.