Diagnostic mode 7: Check test results of components that are continuously monitored: Procedure

Connect diagnostic tester, see CONNECT DIAGNOSTIC TESTER .
Start engine and let run at idle.
NOTE:
Only if engine does not start:
- Operate starter for approx. 6 seconds. Do not switch ignition off afterward.
Under address word 33, select "Diagnostic mode 7: Check test results of components that are continuously monitored".
The number of stored malfunctions or "0 malfunctions detected" is displayed.
End diagnosis and switch ignition off.

Repair stored malfunctions according to DTC table:
- SAE P0xxx-DTCs, see DIAGNOSTIC TROUBLE CODE (DTC) TABLES:
- SAE P1xxx-DTCs, see SAE P1XXX-DTCS
- SAE P2xxx-DTCs, see SAE P2XXX-DTCS

NOTE:

The DTC table is sorted by SAE code.
"E-Gas"-relevant malfunctions are also indicated by the warning lamp for Electronic Power Control ("EPC warning lamp") in the instrument cluster.
Erase DTC memory after repairing malfunction, see DIAGNOSTIC MODE 4: RESET/ERASE DIAGNOSTIC DATA .