Windshield Washer Fluid Level Sensor -G33-

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2014 Volkswagen Golf, 2014 Volkswagen GTI, 2013 Volkswagen Golf R, 2013 Volkswagen Golf, and 2013 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Depending on equipment, the component location of the windshield washer fluid level sensor may deviate slightly from the illustrations. Removal is identical.

Removal

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

Only GTI

-- Remove the front bumper cover. Refer to Front Bumper, GTI .

Continuation for all Vehicles

-- Disconnect the connector -1- from the windshield washer fluid level sensor.

Fig 1: Identifying Windshield Washer Fluid Level Sensor G33 And Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull windshield washer fluid level sensor -2- out of its rubber seal.

-- If necessary, collect the draining fluid in a suitable container.

Installation

Install in reverse order of removal, noting the following:

-- Bleed headlamp washer system after completing assembly work. Refer to HEADLAMP WASHER SYSTEM, BLEEDING .