Instrument Cluster

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2014 Volkswagen Golf, 2014 Volkswagen GTI, 2013 Volkswagen Golf R, 2013 Volkswagen Golf, and 2013 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Prior to replacing the instrument cluster, perform the procedure INSTRUMENT CLUSTER, REPLACE to check the data stored in the control module.

Removal

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

NOTE:

It is not necessary to remove the steering wheel.

-- Pull steering wheel all the way out and lock it in the lowest position.

-- Remove upper section of steering column trim. Refer to Removal and Installation .

-- Remove mounting bolts -arrows- of instrument cluster.

Fig 1: Identifying Instrument Cluster Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the instrument cluster back out of the instrument panel while being careful of the connected wires.

-- Tilt the bracket -1- in the -direction of the arrow- and disconnect the connector -2-.

Fig 2: Identifying Instrument Cluster Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Take the instrument cluster out of the vehicle.

Installation

Installation is performed in the reverse order of removal.