Diagnostic Mode 05 - Read Oxygen Sensor Monitoring Test Results: Notes

NOTE:

Mode 05 may not be supported on all systems. On systems where Diagnostic Mode 05 is not supported, refer to Diagnostic Mode 6 for Oxygen Sensor Monitoring Test Results.

The min & max values for each individual test in Mode 05 represent the min & max operating values for a properly operating system. This data is provided to the individual aftermarket scan tool companies for development of their scan tool. Depending on the scan tool being used, the min & max values shown may vary, or be rounded up or down to the nearest decimal point depending on the aftermarket scan tool company's development process. e.g.:

	Minimum Value
GST Manual documentation	0.3499
Aftermarket Scan Tool display	0.35

Depending on the scan tool and protocol used, the information displayed in Diagnostic Mode 06 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and may be referenced by only a number.

Test requirements

Exhaust system must be properly sealed between the catalytic converter and the cylinder heads.
No DTCs stored in the DTC memory.
Coolant temperature at least 80° C.

Work procedure

-- Connect the scan tool.

-- Start the engine and run at idle.

NOTE:

If the engine does not start, crank the engine using starter for at least 5 Sec, do not switch the ignition off afterward under any circumstances.

-- Select "Mode 5: Check lambda test results.".

-- Select the desired "Test-ID" of the component or system that is to be monitored, e.g. "Test-ID 01: Oxygen Sensor Monitor Bank 1 - Sensor 1".

-- Select the desired "Test-ID".

The current minimum and maximum values will be displayed on the scan tool screen.

The following table is a numerical list of all "Test-IDs" or "Hex-IDs" that may be selected.

Test-ID (Hex-ID)	Component or System
Test-ID 01 ($01) Test-ID 01 ($01): Oxygen Sensor Monitor Bank 1 - Sensor 1	Oxygen Sensor Monitor Bank 1 - Sensor 1
Test-ID 02 ($02) Test-ID 02 ($02): Oxygen Sensor Monitor Bank 1- Sensor 2	Oxygen Sensor Monitor Bank 1- Sensor 2